Troubleshooting

There's a Pink Cut Line in the Print that's supposed to be a cut line

THIS SOLUTION WILL ONLY WORK IF THERE IS A RECTANGLE AROUND THE PRINT

Locate the PRINT FILE

Open the CUT FILE in Zund Editor

Go to File > Add to Job

Select the print file

Delete all the unnecessary data

Rotate the print to match the same orientation

Find the offset of the original rectangle

Make sure the origin point is in the bottom right

Take note of the Pos X and Pox Y

Select the new cut layer

Change the Pos X and Pos `Y to match the Pos X and Pos Y from 7.1

Preform an offset operation of 1mm (Tools > Offset Operation)