Zund G3 Flatbed Cutter

Troubleshooting

There's a Pink Cut Line in the Print that's supposed to be a cut line

THIS SOLUTION WILL ONLY WORK IF THERE IS A RECTANGLE AROUND THE PRINT

  1. Locate the PRINT FILE

  2. Open the CUT FILE in Zund Editor

    image-1652974003364.png


  3. Go to File > Add to Job
  4. Select the print file

  5. Delete all the unnecessary data

    image-1652974163151.png
  6. Rotate the print to match the same orientation

    image-1652974240429.png

  7. Find the offset of the original rectangle
    1. Make sure the origin point is in the bottom right
    2. Take note of the Pos X and Pox Y

      image-1652974311137.png


  8. Select the new cut layer

    image-1652974377162.png

  9. Change the Pos X and Pos `Y to match the Pos X and Pos Y from 7.1

    1. image-1652974416089.png


    2. image-1652974537506.png


  10. Preform an offset operation of 1mm (Tools > Offset Operation)

Access Onyx Thrive Cut Files in Zund Cut Center

Sharing Zund Cut Center / Summa Cut Folder

Step and Repeat

How to copy a cutter/pattern repeatedly over the X and y axis in Zund Cut Center.

 

If you're copying another layout and you want to go over it, measure the distance between the cut lines in the pattern you want to step over to.

Select the object you want to step and repeat with the cursor. (Put your cut line to the bottom right as the multiplier only goes positive on the axis.)

Press Ctrl + D to open the multiplier pop up window.

image-1691504529222.jpg

Use your measurements in the Distance X and Y axis to determine the gap between the cuts.

Now add how many copies you need by entering in the Copy X and Copy Y boxes, these will multiply each other to give you a total amount.

Hit OK to finish.

 


Setting Up Cutter Files

Different Layer Types

Register

Represents the registration dots used for getting the position of the cut layers

Thru-cut

Represents anything to be cut using the drag knife tool (Universal Cutting Tool - UCT) or the Dragging Rotatory Tool (DRT)

Route

Represents anything to be routed using the Router on an inside or outside cut

Engrave

Represents anything to be engraved (i.e. Routed on the cut line)

Drill

Represents anything to be drilled using the Router tool, the Drill option is literally just an up and down motion using the Router tool.  So the drill hole will be the size of the Router bit size.

Crease

Represents anything to creased using the creasing tool (Creasing Tool - CT1)

V-Cut

Represents anything to be cut using the V-Cut Tool (VCT)

Kiss-cut

Represents anything to be Plotted otherwise none as Kiss Cut with the (Kiss Cut Tool - KCT)

Accepted File Types

The Zund Cut Center accepts the following file types:

Warning with PDF Files

Corel draw does not preserve PDF layers in a format that Zund Cut Center accepts, just avoid this file type for cut files.

Setting Up Cut Layers

Examples below in InDesign, Illustrator and Corel Draw

InDesign Example

Illustrator Example

Corel Draw Example

Troubleshooting

Troubleshooting

Zund Camera is not switching on

Reboot the system.

Zund (Zund G3 XL1600CV) Air and Electricity Requirements

Electricity and Air Requirements.pdf